Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and operation of the car

Nissan Patrol and Ford Maverik
- Cars of the Nissan Patrol and Ford Maverick series
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tool and equipment of a workplace
   Automobile chemicals, oils and lubricants
   Poddomkrachivaniye of the car and change of wheels
   Start of the engine from an auxiliary source
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
+ Body
+ Onboard electric equipment

Poddomkrachivaniye of the car and change of wheels

The jack attached in a set to the car is intended only for a car pripodnimaniye for the purpose of change of wheels in road conditions, or for its installation on props.


  1. Park the car away from the highway on the flat horizontal platform, it is desirable with a hard coating.
  2. Turn on the alarm system.
  3. Firmly cock the parking brake. Transfer manual transmission to position of the reverse gear, automatic - to situation "P".
  4. Track that all passengers left salon and prop up to wedges the wheel located on diagonal concerning a subject to removal.
  5. Take a jack and tools.
  6. Remove a spare wheel from an arm or a suspension.
  7. Put on a balloon key a wheel nut so that its handle was placed horizontally and was directed concerning a wheel disk to the left. Having pressed the end of the handle, give a nut 1/2 ÷ 1 turn counterclockwise. Working similarly, weaken the remained nuts of fastening of a wheel.
  8. Get a jack under the corresponding domkratny point under the forward or back bridge (see accompanying illustrations) and slightly raise the car.
Jack institution point under the forward bridge of the car
Jack institution point under the back bridge of the car
  1. Make sure of correctness of placement and stability of a jack.
  2. Lift the car so that the wheel which is subject to change came off the earth. The size of a separation of a wheel has to provide sufficient working space for installation.

Do not perform any works under the car, the lifted situation fixed in only by means of a jack at all! You do not take out a jack out of borders of the site noted by paint under its installation.


  1. Turn off fixing nuts and remove a wheel from the car.
  2. For installation simplification before dressing a wheel, achieve combination of openings in a disk with nave hairpins. In case of need use the handle of a balloon key as the lever for temporary fixing of a wheel in the lifted situation.
  3. Holding a wheel on a nave, freely acquire nuts of its fastening, having pressed their landing cone to edges of an opening in a disk.
  4. Balloon key improve nuts in a diagonal order.
  5. Lower the car on the earth and take a jack.
  1. Balloon key finally tighten nuts of fastening of a wheel in a diagonal order in several stages (see an accompanying illustration).
  1. Remove wedges from under diagonalno the located wheel and remove the removed wheel, a jack and the tool on the regular places.
  2. At the first opportunity make repair of the removed wheel in a tire workshop and check effort of tightening of wheel nuts a dynamometer key.

If the car is completed with wheels with cast disks, repeatedly tighten nuts of fastening of a wheel through 1 000 km of a run.