Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and operation of the car

Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
- Body
   Care of a body
   Removal of spots of various origin from a vinyl upholstery and panels of finishing of salon
   Care of an upholstery and rugs of salon
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Replacement of a windshield and the fixed windowpanes
   Service of forward doors
   Service of back doors
   Removal and installation of a cowl
   Service of doors of a back of models Hardtop and Station Wagon
   Service of a door of a back of models of Utiliti (Van) (Utility)
   Removal and installation of a front grille
   Removal and installation of the central console
   Removal and installation of front seats
   Removal and installation of a back seat
   Service of seat belts
   Removal and installation of the dashboard
+ Onboard electric equipment

Service of a door of a back of models of Utiliti (Van) (Utility)

Removal and installation



  1. Lead round a marker of a plate of loops.
  2. Ask the assistant to support a door in the slightly opened situation and give bolts of fastening it to the case (see an accompanying illustration).
1 — a loop
2 — bolts
  1. Disconnect chains from the party of panels turned to the car and remove a back door.


Installation is made upside-down.


  1. Track that loops were established according to the landing tags put in the course of dismantle.
  2. Strongly tighten fixing bolts of loops.



  1. Weaken bolts of fastening of loops of a door of a back to a body of the car and lift or lower (as necessary) a door so that its upper edge appeared level with the side panel of a body. Also check gap size between bottom edge of a door and the lower body panel has identical width on all the length, and drummers of latches are located on the center of lock loops (see an accompanying illustration).
1 — a back door
2 — a bolt
3 — the handle
4 — a lock loop
5 — the drummer
  1. Strongly tighten bolts of fastening of loops.