Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and operation of the car

Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
- Body
   Care of a body
   Removal of spots of various origin from a vinyl upholstery and panels of finishing of salon
   Care of an upholstery and rugs of salon
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Replacement of a windshield and the fixed windowpanes
   Service of forward doors
   Service of back doors
   Removal and installation of a cowl
   Service of doors of a back of models Hardtop and Station Wagon
   Service of a door of a back of models of Utiliti (Van) (Utility)
   Removal and installation of a front grille
   Removal and installation of the central console
   Removal and installation of front seats
   Removal and installation of a back seat
   Service of seat belts
   Removal and installation of the dashboard
+ Onboard electric equipment

Removal and installation of a front grille

The order of performing procedures of removal and installation of a front grille is identical to all cars of models. Below procedures for models Hardtop and the Versatile person are described.



  1. Lift a cowl and record it an emphasis.
  2. Give screws of fastening of the combined lamps to the car front panel. Remove lamps, previously having disconnected from them an electrical wiring.
  1. The screw-driver turn clamps on a quarter of a turn (are shown by shooters on accompanying illustrations (Utiliti (Van) and the Mini-truck) and (Hardtop and the Versatile person)).
  1. Slightly incline a front grille forward, then pull it for removal up.

On some cars perhaps previously it is necessary to remove a frame of a skotootboynik (depending on its design).


Installation is made upside-down.


  1. For extraction of clamps from the panel of a front squeeze them and turn on a quarter of a turn.
  2. Insert clamps into square openings in a lattice, turning them then.
  3. Establish a front grille on the lower reference points and push it for a zashchelkivaniye of clamps in the ancestor's panel back.
  4. On models Hardtop and the Versatile person establish the combined lamps, having strongly tightened screws of their fastening.