Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and operation of the car

Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
- Body
   Care of a body
   Removal of spots of various origin from a vinyl upholstery and panels of finishing of salon
   Care of an upholstery and rugs of salon
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Replacement of a windshield and the fixed windowpanes
   Service of forward doors
   Service of back doors
   Removal and installation of a cowl
   Service of doors of a back of models Hardtop and Station Wagon
   Service of a door of a back of models of Utiliti (Van) (Utility)
   Removal and installation of a front grille
   Removal and installation of the central console
   Removal and installation of front seats
   Removal and installation of a back seat
   Service of seat belts
   Removal and installation of the dashboard
+ Onboard electric equipment

Service of seat belts

General information

Front and external back seats are equipped with seat belts of inertial type. Belts cover a chest and zone part of a trunk of passengers.

The central back seat is equipped with a zone belt with manual adjustment.

It is necessary to check a condition of all seat belts regularly. At any doubts in serviceability of a state or functioning of assemblies they should be replaced.

Check of a state


  1. Check material of belts for existence of attritions, istrepyvaniye, cuts, prozhog and other damages. The inertial belt should be extended completely, having winded from a drum and to examine on all its length. In case of detection of defects assembly of a belt should be replaced.
  2. Make sure that belts are not overwound.
  3. Check reliability of tightening of fixing nuts and bolts.
  4. Check serviceability of functioning of buckles of belts. In case of detection of any defects the corresponding belt has to be replaced assembled.
  5. On belts of inertial type check serviceability of functioning of the returnable mechanism:
    1. Slowly extend a belt, checking smoothness of its course. Release a belt and make sure that it regularly comes back to a starting position.
    2. Sharply pull a belt, - the drum has to be blocked.
    3. Moving at a slow speed try to extend slowly a belt during sharp braking - the drum besides has to be blocked.
  6. If the returnable mechanism does not function properly, replace defective assembly.