Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and operation of the car

Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
- Engine
   - Engine of 4.2 l
      Removal and installation of the engine
      Removal, dismantling, check of a state and installation of assembly of yokes and bars of pushers
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Service of a head of cylinders
      Removal, check of a state and service of components of the drive of the gas-distributing mechanism (chain and asterisks)
      Removal, check of a state and installation of the camshaft and pushers
      Removal and installation of the pallet of a case and maslozabornik of the oil pump
      Service of the oil pump
      Replacement of epiploons of a bent shaft
      Service of conrod and piston assemblies and mirrors of cylinders
      Service of a bent shaft and radical bearings
      Service of a flywheel / driving disk
      Removal and installation of support of the power unit
   + Engine of 3.0 l
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
+ Body
+ Onboard electric equipment

Removal and installation of a final collector



  1. Disconnect a negative wire from the battery.
  2. Working under the car, give bolts of fastening of a reception pipe of system of production of the fulfilled gases to a final collector. Disconnect a pipe from a collector.
  3. Remove the air duct passing between the air cleaner and a cyclonic pyleotdelitel of preliminary cleaning.
  4. Give fixing bolts and remove the thermofilter from a final collector. Remember a point of connection of the tire of grounding.
  5. Moving on a spiral outside inside, gradually weaken fixture of a final collector.
  6. Remove fixing bolts, nuts and their washers and take assembly of a final collector from a motive compartment (see an accompanying illustration).
1 — the thermofilter
2 — a final collector
3 — laying
  1. Check the interfaced surfaces of a final collector for existence of cracks, deformations and other damages. Execute necessary repair, or replace a collector.



  1. Installation is made upside-down.
  2. Do not forget to smooth out previously carefully interfaced surfaces and to replace all laying.
  3. Do not forget to establish under washer fixture. Tighten fixture with the required effort, moving on a spiral from within outside.
  4. At installation of the thermofilter do not forget to connect the grounding tire.

In order to avoid a prikipaniye and for the purpose of ensuring further maintainability of the equipment grease fixture carvings before installation by the suitable anti-taking sealant.

  1. Start the engine and check a collector for leak of the fulfilled gases