Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and operation of the car

Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating and air conditioning
- Power supply system and production of the fulfilled gases
   - Power supply system of carburetor engines (3.0 l and early 4.2 l)
      Removal and installation of the air cleaner and pyleotdelitel of preliminary cleaning
      Removal and installation of the fuel filter
      Service of the carburetor
      Service of the fuel pump
      Service of the electromagnetic valve of return of fuel - only models of 3.0 l
      Service of a cable of the drive of a butterfly valve
      Service of a cable of the manual drive of a butterfly valve
      Service of the fuel tank
   + Systems of injection of fuel (EFI) and engine management - model of 4.2 l of release after 1992.
   + System of production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
+ Body
+ Onboard electric equipment

Service of the fuel tank

The procedures described below are applicable to models with a body the Versatile person and Hardtop. For other types of bodies works are performed similarly with necessary amendments on design features of a body.

Removal and installation



  1. Disconnect a negative wire from the battery.
  2. In the luggage compartment give fixing screws and remove fastened hooks.
  3. Give fixing screws and remove finishing of fastening of a rug from back door shutters.
  4. Put a rug forward and give screws of fastening of a cover of access. Uncover.
  5. Disconnect also to a zakuporta fuel hoses. Disunite the electric socket.

Fuel consumption sensor block, and on models of 3.0 l also a gasoline pump, can be taken from the fuel tank for performance of necessary repair after fixture otdavaniye now. The sensor of fuel consumption of models of 4.2 l taken from a gasoline tank is shown on an accompanying illustration.

  1. Car back also establish to Poddomkratta it on props.
  1. Carefully turn out a drain stopper of a gasoline tank (see an accompanying illustration) and merge fuel in a pure canister. Screw a stopper into place and strongly tighten it.
  1. Working through an aperture of an arch of the right back wheel, give bolts of fastening of the filter of a jellied mouth to the tank case, remove the screen.
  2. Weaken collars of fastening of a jellied mouth and a tube of withdrawal of fuel evaporations (the corresponding components of a tank of models of 4.2 l are shown on an accompanying illustration).
1 — a jellied mouth
2 — fuel consumption sensor
3 — a tube of withdrawal of evaporations
4 — the control valve
  1. Give fixing bolts and lower the gasoline tank filter down.
  2. Give bolts of fastening of a tank to the chassis and carefully take a tank from under the car. Before extraction of a tank once again make sure that the jellied mouth and a tube of withdrawal of fuel evaporations are disconnected.


Installation is made upside-down.


  1. Track that all hoses were in good repair and are connected correctly to the unions.
  2. At installation of a tank track correctness of connection of tubes of a jellied mouth to it and withdrawal of fuel evaporations.
  3. Fill in pure fuel in a tank and check it for leaks.